3
28. Do not stand on the machine. Serious injury
could occur if the machine tips over.
29. Never leave the machine running unattended.
Turn the power off and do not leave the
machine until it comes to a complete stop.
30. Remove loose items and unnecessary work
pieces from the area before starting the
machine.
31. Keep hands and fingers away from moving saw
blade.
32. Don’t use in dangerous environment. Don’t use
power tools in damp or wet location, or expose
them to rain. Keep work area well lighted.
Additional safety instructions for
scroll saws
33. Scroll saw must be secured to a sturdy
foundation. If there is a tendency for the stand
or workbench to move, it must also be secured
to the floor.
34. Blade must be properly tensioned before
operating. Failure to do so could result in blade
breakage and possible injury.
35. Never start saw with workpiece contacting
blade.
36. Always keep fingers and hands away from
blade. Avoid awkward hand positions where a
sudden slip might cause hand to move into or
toward the blade.
37. Always hold stock firmly against table. The
provided hold-down should be correctly
positioned over the workpiece.
38. Do not attempt to saw any stock that does not
have a flat surface, without a suitable support.
Do not cut pieces of material too small to hold
by hand.
39. Care must be taken when cutting material with
an irregular cross section. The blade could
pinch before the cut is completed. Any stock,
such as frame molding, must lie flat on the table
surface and not be allowed to rock.
40. Dowels or tubing have a tendency to roll while
being cut and cause the blade to “bite.” Round
material should be held firmly against the table.
41. Turn off saw before backing stock out of an
incomplete cut. Only remove jammed cut-off
pieces after blade has stopped.
42. Make “relief” cuts before cutting long curves.
43. When cutting large or oversize stock, always
make sure material is supported at table height.
44. Do not feed workpiece too fast while cutting.
Feed workpiece only fast enough for the blade
to cut.
45. Never reach under the table while blade is
moving.
Familiarize yourself with the following safety notices used in this manual:
This means that if precautions are not heeded, it may result in minor injury and/or possible
machine damage.
This means that if precautions are not heeded, it may result in serious, or possibly even fatal,
injury.
SAVE THESE INSTRUCTIONS
To Next Page
Loading...
Need help?
General
