18
Operation Manual
Trailer Breakaway System
The trailer is equipped with a breakaway system
in the event that the trailer should come un-
hitched from the tow vehicle. If this occurs, the
breakaway system will apply the trailer brakes to
bring the trailer to a stop.
The breakaway system includes a battery (Fig-
ure 26) and a breakaway switch (Figure 27).
Both components are located in the tongue
area.
In the event of a separation, the lanyard (Fig-
ure 27) would be pulled from the breakaway
switch which closes a set of contacts. Voltage
from the breakaway system battery is sent
through the closed contacts in the switch to
the brake magnets in the drum brakes. The
magnet actuates the brakes to stop the trailer.
The battery is connected to the tow vehicle
charging system, if properly wired, to provide
charging when being towed. Check the battery
for proper voltage before towing.
Refer to the connector wiring decal located on
the side of the tongue.
Activating the System
1. When attaching the trailer to the tow ve-
hicle, attach the loose end of the lanyard
to the tow vehicle hitch.
2. Ensure the trailer electrical connector is
properly connected.
Battery
Figure 26: Breakaway System Battery
Lanyard
Figure 27: Breakaway Switch and Lanyard..
Breakaway Switch
To Next Page
Loading...
