29
FUEL MIXING
JetSurf
TM
uses mixture of gasoline (natural 95 octane) and oil (full synthetic).
Every time use only petrol mixing bottle container approved for gasoline mixing. This petrol mixing
bottle container must be approved - D.O.T (USA) or CE (Europe).
Use lead-free car petrol with the octane number 95 or higher mixed in the proportion of fty (50)
parts of fuel to one (1) part of MOTOREX OCEAN FS 2T BIO; or oil meeting these standards: NMMA
TC-W3, API TC, ISO-L-EGD: JASO FD/FC; TSI.
Make sure that petrol and oil are mixed properly in the correct propor-
tion. If the proportion is not observed, the engine may get damaged.
Before every ride, make sure that the fuel tank is fastened well using a velcro. A slight sideways move-
ment after applying force is normal but it MUST NOT COME INTO CONTACT WITH ANY PART OF THE
ENGINE DURING THE OPERATION. Pay special attention to the safe distance between the gear cover
and the fuel tank and make sure they cannot come into contact.
LUBRICATION
Before the ride it is recommended to lubricate the engine with a conservation spray, e.g. MOTOREX
INTACT MX 50, mainly before riding in salt water. Sea water causes corrosion of metal parts of
the engine and if you spray these parts with a preservation spray, you will decrease the
corrosive eects of salt water.
Regularly inject preservative spray to the lubrication holes - FIGURE 1 and 2. Apply preserv-
ative spray also to the muer and alternator bearing - FIGURE 3 and 4 on the next page.
GENERALLY, SPRAY THE WHOLE ENGINE.
PETROL TO OIL
MIXTURE
50 parts of
petrol
1 part of oil
Example:
To 1 litre of petrol
add 0.02 l (20 ml) of oil
To 2 litres of petrol
add 0.04 l (40 ml) of oil
50 : 1
RIDE
CAUTION
To Next Page
Loading...
