4
INTRODUCTION
USER MANUAL
Copyright 2019; All rights reserved
JetSurf™ motorized power boards were designed and manufactured by MotosurfWC and Formula 1 engi-
neers to push the limits of motor sports. The power boards created by JetSurf™ are the only motorized water
vehicles with the ability to be transported by hand, car, boat or plane (as hand luggage on international/
domestic carrier ights). This allows the users of JetSurf™ power boards to travel easily around the word –
aunique attribute in comparison to other motorized watercraft.
JetSurf™ parts and components are manufactured by MSR Engines, based in the Czech Republic. Thecom-
pany specializes in the development of combustion engines and specialized electronics.
JetSurf™ power boards are produced in a single factory that uses the highest standards of production technology.
Only the nest materials and components currently produced in the European Union are utilized. This compre-
hensive in-house production allows JetSurf™ to ensure themaximum precision and ecient production. Since
2017 the manufacturer has been an ISO 9001 certicate holder.
JetSurf™ power boards were developed with exceptional eort to minimize environmental impact. JetSurf™
power boards meet homologation (registration for racing) standards for noise emissions, as well as using an
internal combustion engine that enforces the Greentech technology and complies with the emission limits set
for motor vessels. The complete drive unit is certied and approved by the European Commission and received
the European Union label, CE. All this eort toward compliance with international standards has ensured that
the power boards are also compliant with North American requirements for personal watercraft.
EPA Emissions Regulations:*
JetSurf motorized surfboards are certied to the United States Environmental Protection Agency (EPA) as con-
forming to the requirements of the regulations for the control of air pollution from new watercraft engines. This
certication is contingent on certain adjustments being set to factory standards. §1068.101(b)(1) prohibits tam-
pering, removal or rendering inoperative any device installed onto the engine in compliance with EPA regulations
prior to sale and delivery to, as well as after the sale to, the ultimate purchaser of the product.
Maintenance, replacement, or repair of the emission control devices and systems may be performed by any
marine engine repair establishment or individual.
Emission Control Information is printed onto the Engines as permanent evidence of EPA certication.
The information contained in this User Manual represents the most up-to-date product data available at the
time of printing. Because JetSurf™ is committed to continuous product improvements and advancement
of technology, the company reserves the right to change the product, components, specications or other
aspects of the JetSurf™ motorized power board without advance notice or a requirement to equip previously
produced JetSurf™motorized power boards with these changes. You can nd current upgrades on the Jet-
Surf™ websites (www.jetsurf.com). Check this website regularly.
This User Manual for Owners or Operators (hereafter referred to as the “User Manual”) cannot anticipate
every circumstance involved in owning or operating the motorized power board. JetSurf™ strongly encour-
ages owners and operators to regularly review the U.S. Coast Guard website (www.uscg.mil) or the relevant
coast guard and/or authority regulating the laws pertaining to the use of personal watercraft with particular
attention to information provided for personal watercraft. Also check JetSurf™ company’s website (www.
jetsurf.com) for updates and product information.
JetSurf™ provides the following information in the expectation of long and enjoyable ownership of this
JetSurf™ motorized power board.
* Valid for the USA
To Next Page
Loading...
