JETSURF ADVENTURE DFI PLUS - Maintenance of Bilge Pump; Maintenance of Exh. Silencer

45
DFI003/EN_part A
ltr
OBRÁZEK 2
2) With a slight upward lift, pull out the bilge pump.
3) Clean the bilge pump lter – FIGURE 2.
4) Put the bilge pump back and screw in the screw again.
EXHAUST SILENCER MAINTENANCE
Before every ride, apply conservation spray in the inner part of the silencer – e.g. MOTOREX INTACT MX
50, chapter BEFORE YOU START.
After every 10 MH clean the exhaust silencer.
SILENCER CLEANING PROCEDURE:
What you need: degreaser and a cloth
1) Loosen the nut – FIGURE 1 and remove the silencer from the exhaust.
2) Remove the spring and valve from the exhaust – FIGURE 2.
3) Clean all the removed parts thoroughly.
4) Reinstall the valve, spring and silencer and tighten the nut.
Attention: The spring has a conic shape. The valve therefore has to be attached at the side with the
bigger diameter. The spring side with the smaller diameter is to be placed to the recess in the cover.
MAINTENANCE
lter
FIGURE 1
FIGURE 2
nut
valve spring
FIGURE 2FIGURE 1