JETSURF ADVENTURE DFI PLUS - Water Removal from the Flooded; Engine

38
DFI003/EN_part A
WATER REMOVAL FROM THE FLOODED ENGINE
Although the JetSurf™ is equipped with systems for removing water from the power board, it can
happen that some water gets into the engine compartment and then it oods the engine through or
exhaust. In such a case, the JetSurf™ will not start and it will be necessary to remove the water from
the engine.
PROCEDURE
1) Take the holder from the spark plug boot - FIGURE 1 and remove the boot from the spark plug
- FIGURE 2. Screw the spark plug out using a spark plug spanner which is supplied within the ac-
cessories. Dry the spark plug properly. If the spark plug has been in operation for more than 6 hours, it
should be replaced.
2) Tilt the JetSurf™ towards the spark plug opening down (its head engine) . When the spark plug screwed
out, start turning the shaft with your hand. While turning the shaft, you should see water coming out
head engine. Continue until water stops coming out.
3) If no more water is coming out of the engine head, place and keep the key on the indicator – FIGURE 3.
When the shut-o key is placed, the starter starts turning without ignition on the spark plug. Continue
turning the engine until only fuel is splashing out of the spark plug opening (fuel and water form a
white emulsion).
RIDE
FIGURE 1
FIGURE 2
FIGURE 5FIGURE 3