39
ATTENTION: The third point can only be performed if most of the water has
already been pumped out manually or otherwise there is a danger of dam-
age to the starter. Do not turn the starter longer than 10 seconds.
4) Screw the spark plug back in following the instructions in the section Spark plug.
5) Put the spark plug boots back in place and secure it with a boot holder.
6) Start the engine for maximum 5-10 seconds to make sure that it works correctly. The engine should
not be run without cooling for more than 10 seconds (temperatures of cylinder shouldn’t be higher than
65°c/147°F) or otherwise it can get overheated and damage.
Never insert the engine shut-o key in the handle when the spark plug
is out.
Make sure that the boot covers the spark plug completely when mounted.
RIDE
NOTICE
To Next Page
Loading...
