JETSURF ADVENTURE DFI PLUS - Component Checks Before Ride

24
DFI003/EN_part A
NEVER leave the side ns screws loose in the board during transporting
the JetSurf™, always pull them out. Similarly we recommend screwing
the main n screws into the base even without the n.
STRAPS
JetSurf™ have fully adjustable straps. They can be adjusted by pulling the loose ends of straps with
force or by means of plastic buckles. Make sure that the straps are comfortable and are not too
loose or tight.
HOSES
Check all the connections. Check also all the hoses whether they are not worn or cracked. Check for
cuts, scratches, cracks and bulges. Make sure that the hoses are not kinked or squeezed and that
there is no fuel leak.
CHECK ALL OF THE FOLLOWING: fuel hoses, transparent hose of exhaust cooling, blue cooling hoses,
drain hoses.
If a tube is damaged in any way, replace it immediately and check all the other tubes whether they
are not damaged.
Make sure that all the tubes are laid correctly and fastened with clamps at a sucient distance from
the moving parts and parts with sharp edges.
ELECTRIC CONNECTIONS
Before the ride check ALL the electric connections carefully. Pay special attention to the spark plug
boot (to prevent it coming loose during the ride), correct placement of the feeding cable from the ICU
and proper fastening of all the connections. Also make sure that the cover of charging cable is properly
connected when the board is not being charged.
Before every ride, remove the spark plug and check it. Generally, for proper operation of the
power board, Jetsurf recommends changing the spark plug every 6 hours of the ride.
Check whether all the connections are fastened properly by pulling both ends slightly away from
each other. If you are not sure, we recommend disconnecting and reconnecting. The connectors are
equipped with a clip which must be pushed when being disconnected (preferably with thumb) until
it “clicks”. After the clip is released, you can disconnect the connector. To reconnect the connectors,
simply push both ends together until you can hear a click.
CONTROL HANDLE
Check the throttle trigger allowance. If the allowance is incorrect, adjust the throttle cable. Check
several times whether the throttle trigger moves smoothly from the fully open position to the fully
closed position and that it closes quickly and completely by means of a return spring.
If the throttle trigger does not return correctly, check the throttle cable line, cable adjustment and
cable damage.
ALTERNATOR
The alternator ensures sucient charging of the ICU battery while driving. If the board has not been
used for more than 30 days, check the ICU battery status.
RIDE
CAUTION