22
RIDE
3A RIDE
BEFORE YOU START
Before your rst ride without being supervised by a Authorized Dealer or a coach of JetSurf, please
make sure that you have read and understood the manual supplied together with the power board.
Familiarize yourself with the laws valid for the water bodies where you intend to use your motorised
power board.
STAND AND ITS UNFOLDING
Every JetSurf™ is supplied with a light stand. The stand should be used on a solid levelled surface and
it is only used to keep the JetSurf motorized power board in a comfortable height. Use of the JetSurf
stand is strongly recommended to keep the JetSurf motorised power board above the ground, it is
intended as an aid for preparation, maintenance and cleaning of the motorized power board.
STAND ERECTIONje
Place all four rods parallel - FIGURE 1. Take the ends of the rods which are farther from the stand
clip and turn them gently clockwise – FIGURE 2. Then take the opposite ends of two rods (the
side where the ends of the rods are closer to the stand clip) and pull these ends apart – FIGURE 3.
Make sure that the stand is situated on the solid surface and that the power boards rests on the
stand correctly (the engine should be directly above the stand and all four rods of the stand touch
the power board).
FINS
FASTENING OF SIDE (SMALL) FINS FCS
The standard side ns (supplied by the manufacturer) are specic to the left and right sides - FIG-
URE 1 on the side. THEY ARE NOT INTERCHANGEABLE!
FIGURE 1 FIGURE 2 FIGURE 3
To Next Page
Loading...
