EasyManua.ls Logo

JETSURF ADVENTURE DFI PLUS - A Brief List of Tasks to be Done; The Tasks to be Done after the Ride

JETSURF ADVENTURE DFI PLUS
68 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
37
DFI003/EN_part A
A BRIEF LIST OF TASKS TO BE DONE BEFORE THE RIDE
Attach all the ns page 22/part A
Set the straps page 24/part A
Charge the battery in the ICU page 25/part A
Top up the fuel page 29/part A
Check the tubes of the cooling system and all the connections and tubes page 24/part A
Check whether all the connectors are connected page 24/part A
Check the spark plug boot, check the spark plug, check the spark plug boot hold-
er (safety spring) so that boot can’t get loose while riding
page 42/part A
Check the throttle control and fuel system page 24/part A
Spray thoroughly all the engine parts with MOTOREX INTACT MX 50 oil page 29/part A
Start the engine, check the engine operation and throttle control;
MAXIMUM FOR 10 seconds!!! Otherwise the engine can overheat and
destroy the exhaust system.
page 24/part A
Check the bilge pump
Apply the grease in the exhaust silencer page29/part A
A BRIEF LIST OF THE TASKS TO BE DONE AFTER THE RIDE
Tilt the JetSurf
TM
and pour the water out of it page 36/part A
Start the JetSurf
TM
with its tip up, MAXIMUM FOR 10 seconds!!! page 36/part A
Wash the whole JetSurf
TM
with fresh water, including the engine compartment,
then let the engine run for about 5 seconds (MAXIMUM FOR 10 seconds)
page 36/part A
Let the JetSurf
TM
dry page 36/part A
Spray all the engine parts thoroughly with MOTOREX INTACT MX 50 oil page 29/part A
Charge the ICU battery page 25/part A
Store your JetSurf
TM
with the open engine cover
RIDE

Table of Contents

Related product manuals