PowerBoost DC Converter System 1.5: Quick Start Guide
16995-01 rev. D
This document contains proprietary information. No part of this document should be reproduced
or distributed beyond its intended recipients without the express written consent of JMA Wireless. 29
Touch the blue checkmark to confirm.
Allow a few seconds for the change; config status will indicate “synchronized.”
Once the configuration file is selected and implemented:
• With all OMM circuit breakers OFF, insert boost modules only for the channels that are
enabled.
• It is recommended to turn on the OMM circuit breakers one at a time, and verify that
the expected Raycap channel energizes.
• Confirm/troubleshoot as appropriate.
• Optional: once all channels are energized, one can proceed to Appendix I for closeout
checklist.
To Next Page
Loading...
Need help?
General