General safety guidelines
Important: Read before proceeding.
This equipment is a relatively complicated apparatus. During rigging, installation, operation,
maintenance, or service, individuals might be exposed to certain components or conditions
including, but not limited to: heavy objects, refrigerants, materials under pressure, rotating
components, and both high and low voltage. Each of these items has the potential, if misused or
handled incorrectly, to cause bodily injury or death. It is the obligation and responsibility of rigging,
installation, and operating and service personnel to identify and recognize these inherent hazards,
protect themselves, and proceed safely in completing their tasks. Failure to comply with any of
these requirements could result in serious damage to the equipment and the property in which it is
situated, as well as severe personal injury or death to themselves and people at the site.
This document is intended for use by owner-authorized rigging, installation, operating, and service
personnel. It is expected that these individuals possess independent training that will enable
them to perform their assigned tasks correctly and safely. It is essential that, before performing
any task on this equipment, this individual must read and understand the on-product labels, this
document and any referenced materials. This individual must also be familiar with and comply with
all applicable industry and governmental standards and regulations relating to the task in question.
Safety symbols
The following symbols are used in this document to alert the reader to specific situations:
DANGER
Indicates a possible hazardous situation which will result in death or serious injury if correct care is not
taken.
WARNING
Indicates a potentially hazardous situation which will result in possible injuries or damage to equipment
if correct care is not taken.
CAUTION
Identifies a hazard which could lead to damage to the machine, damage to other equipment and
environmental pollution if correct care is not taken or instructions are not followed.
Note: Highlights additional information useful to the technician in completing the work being
performed correctly.
5
YMC
2
Mod B with OptiView Control Center
To Next Page
Loading...
Need help?
General
