Treadmill will not start
Possible causes:
1. MCB is damaged.
2. 6-pin console cable
is damaged.
3. PCB is damaged.
4. Motor is damaged.
Fix:
Open motor cover, verify wire connection A1 and A2
(motor wire) on the MCB then plug in the power cord
and turn on the power switch. Then press “POWER,
START, FAST“ buttons.
1.
Verify the LED indicator of
MOTOR
is lit.
If that LED MOTOR is not lit, replace MCB.
2. Verify if LED M.C.SIG is lit. (If it is not lit,
replace 6-pin console cable.)
3. If LED M.C.SIG is still not lit, replace PCB.
4. Replace Motor.
6-6 Revision: 1.0 Date: 2001-06-01
To Next Page
Loading...
