DECK RE-WAXING PROCEDURE
Frequency:
Every 1 month.
WAX
Name: CHRIS TIAN
Content:
SUNWAYLUBE 1180
Viscosity Grade 68
Viscosity @40C 68.0
@100C 9.1
Viscosity Index 100
Pour Point, C 12
Flash Point, C 216
Procedure:
1. After removing the running belt, clean the deck and
belt by using a clean towel.
2. Place the (new) running belt.
3. Place some wax on the deck about 10 cm from the edge,
in such that the wax is evenly distributed across the
deck.
4. Tighten the deck screws and assemble the rear roller
first, then assemble the front roller.
5. Replace the drive belt on the transmission pulley by
turning the Flywheel clockwise by using left hand and
use right hand to push the drive belt on to grooves of
the front roller pulley.
6. Install the front / rear rollers. Adjust the roller fixed
bolts to center the running belt at speed 4mph (6.4kph).
7. Turn on the power and then press the start key, then
hold down the fast key until the window indicates 2
mph (3 kph) and then step on the belt for 5 minutes
to ensure the wax has been evenly distributed
underneath the belt.
1-3 Revision: 1.0 Date: 2001-06-01
To Next Page
Loading...
Need help?
General
