CONSOLE CABLE REPLACEMENT (JET6000)
Tools required:
ü Philips screwdriver
ü T-handle key
(5mm).
Procedure:
1. Remove screws from the
motor cover by using the
screwdriver.
2. Remove screws from the right support with the T-
handle key (5mm).
3. Remove the screws from the console cover.
4. Disconnect the console cable from the PCB and
MCB.
5. Pull out the snap bushing first then tie the old cable to
the new one with a rigid string.
6. Pull the old cable from the top end until the new
cable threads all the way through the right support
and the console bare.
7. Connect the console cable to PCB and MCB.
8. Install the console cover and tighten the screws.
9. Install the front cover and tighten the screws.
7-4 Revision: 1.0 Date: 2001-06-01
To Next Page
Loading...
Need help?
General
