Johnson JET7000 User Manual

Error message on console
JET6000/7000N
Error
message
cause solution
Err2
P0 P1 P2 P4 P5 have a wrong
parameter values
l Re-calibrate all parameter
values in Engineering Mode
Err3 VR is open loop or short
• Re-plug or replace the Incline
Motor(Jet6000)
• Re-plug or replace the
VR(Jet7000)
• Re-plug or replace the 8-pin
console cable
• MCB or PCB is damaged
Err6
No elevating after press the “up”
or “down” key about 5 seconds
l Re-calibrate the “P4, P5”
parameter values.
JET7000E
Error
message
cause solution
Err2 EEPROM Checksum error
l Re-calibrate all parameter
values in Engineering Mode
6-11 Revision: 1.0 Date: 2001-06-01

Johnson JET7000 Specifications

General

Brand	Johnson
Model	JET7000
Category	Treadmill
Language	English