Heart-Rate-Control function does not work
Possible causes:
1. Transmitter does not
contact with user's
chest very well.
2. Transmitter(Polar-
belt) is at low battery
status.
3. Transmitter(Polar-
belt) is damaged.
4. Heart-rate-control
board is damaged.
5. PCB is damaged.
Fix:
1. Center the
transmitter on your
chest below the
pectoral muscle(breast)
as shown, then check again.
2. Remove the battery cover of the transmitter.
Replace a new battery and check again.
u Actually, as moisture may activate the
transmitter, please dry transmitter after use.
OR
3. Transmitter is damaged.
Replace the Transmitter.
OR
4. Heart-rate-control board is damaged.
Replace the Heart-rate-control board.
OR
5. PCB is damaged.
Replace the PCB.
6-7 Revision: 1.0 Date: 2001-06-01
To Next Page
Loading...
