ELEVATION RACK REPLACEMENT (JET-7000 series)
Tools required:
ü Philips
screwdriver
ü T-handle
key(5mm)
Procedure:
1. Turn on the power and keep the incline at the minimum
elevation. Then turn off the power.
2. Remove the front cover.
3. Disconnect console
cables from the MCB.
4. Use the T-handle key
(5mm) to loosen screws and
remove the stanchion
together with console base.
5. To prevent the frame from fall down heavily while
remove the elevation rack & outer pinion & rack
cover, please put a support with proper height (9cm)
under the front of frame before the replacement.
6. Loosen the screws
from the right/left rack &
pinion outer cover by
using T-handle key (5mm)
and remove the covers.
7-10 Revision: 1.0 Date: 2001-06-01
To Next Page
Loading...
Need help?
General
