ELEVATION RACK REPLACEMENT (JET-7000 series)
Tools required:
ü Philips
screwdriver
ü T-handle
key(5mm)
Procedure:
7. Remove the elevation rack. Then remove the C clip of
the transportation wheel to remove the transportation
wheel.
8. Attach the new elevation rack on to the transportation
wheel and attach C clip, then attach the elevation rack
onto the incline gear and install the covers.
9. Remove the support .
10. Install and tighten the left / right stanchion and connect
console cables to the MCB.
11. Turn on the power and enter the Engineering Mode to
check if the minimum and maximum elevations are
within the limits.
12. Install the front cover and secure the screws.
7-10 Revision: 1.0 Date: 2001-06-01
To Next Page
Loading...
Need help?
General
