Treadmill will not start
Possible causes:
1. MCB is damaged.
2. 8-pin console cable is damaged.
3. PCB is damaged.
4. Motor is damaged.
Fix:
Open motor cover, verify wire connection MTR1 and MTR2 on the MCB then
plug in the power cord and turn on the power switch. Then press
“START“ key.
1.
Verify the LED indicator of MOTOR is lit.
(
If that LED MOTOR is not lit, replace MCB.)
2.
Verify if LED PWM is lit.
(if it is not lit, replace 8-pin console cable.)
3. If LED PWM is still not lit, replace PCB.
4. Replace Motor.
To Next Page
Loading...
