Johnson T8000 - Error Message E1; Error Message E3 and “E6”

Error Message " E1"
Possible cause:
1. speed sensor cable damaged.
2. MCB is damaged.
3. Check the magnet on the front roller.
4.
Fix:
1. Check the connector condition of the speed sensor cable.
2. Check the speed sensor wire not to touch the P1 of the MCB.
3. Check the magnet whether on the front roller.
Error Message " E3" and “E6”
Possible cause:
1. The incline motor was broken or the cable was lost.
2. The 8 pin signal cable was lost..
Fix:
1. Check the incline motor cable or the 8 pin cable.
2. Replace the incline motor.