English – 11
ADD
FULL
ADD
FULL
Steering wheel
• Fit the steering wheel with the steering column
tube on the steering shaft.
• Screw in the socket head cap screw so that it
goes in the slot on the steering shaft. Work on
the steering wheel and tighten the socket head
cap screw so that it bottoms in the slot.
• Fit the lock nut on the socket head cap screw.
Tow plate
The tow plate is fitted the “wrong way round” at the
factory for transport reasons. Fit the tow plate on
the rear bumper as shown in the diagram.
Check the oil level in the engine
Check the oil level in the engine when the machine
is standing level.
Lift up the engine cover.
Loosen the dipstick and pull it out. Wipe the
dipstick and replace it.
The dipstick should be screwed fully down.
Loosen the dipstick and pull it out again. Check the
oil level.
The oil level should lie between the markings on the
dipstick. If the level is close to the “ADD” mark, top
up with oil to the “FULL” mark on the dipstick.
The oil is poured in the same hole the dipstick fits
in.
Use engine oil SAE 30 or SAE 10W-30, grade SF–
CC.
The engine takes a total of 1.4 litres of oil.
Delivery and dealer service
To Next Page
Loading...
