Jonsered FR13 - Removal of Belt

English – 43
8
9
Reparation instructions
Changing oil – FRM 13 A
Empty the hydrostatic transmission with the two
plugs, width across flats 14 mm. The other screws
have smaller widths.
Fill up with oil in the oil tank.
Bleed the transmission as directed in “Bleeding of
the hydrostatic transmission’s oil system”. Top up
with oil after bleeding.
Test run the machine and recheck the oil level.
IMPORTANT INFORMATION
Spent engine oil is hazardous to health
and must not be poured out on the
ground or in the nature, but should be
handed in to a designated place for
recycling.
Avoid skin contact and wash any spillage
with soap and water.
Removing the belt
FR 13 and FRM 13 A
Starting point when Removing the belt:
• A deck is not mounted on the machine.
• The front part of the belt hangs loose.
The complete belt is removed as follows only if a
snow blade is to be fitted on the machine.
1. Loosen the belt guide and support pulley.
2. Loosen the belt tensioning pulley.
3. Prise the belt off the middle pulley and remove
the belt.
Reverse the above sequence to refit the belt.