Jonsered FR13 - Adjusting Cutting Height Area; Adjusting Cutting Height

English – 45
1
2
11
3
1
2
Adjusting cutting height area
Raise or lower the entire mowing deck by screwing
the nuts up or down.
If the highest cutting height is raised by 5 mm the
other fixed cutting heights will also be raised by the
same amount.
Remove the right-hand fender.
Adjusting cutting height
• Loosen the nuts on the height setting arm.
• Adjust so that the distance between the stop for
the lowest height setting and the protective
frame is 5 mm.
• Tighten the nuts.
• Check that the parallelism has not changed. If it
has changed, the parallelism must be
readjusted again.
• Check and adjust the cutting unit’s ground
pressure as set out (see “Checking and
adjusting cutting unit ground pressure”) if
necessary.
• Fit the nose.
NOTE!
The parallelism and height must be
Reparation instructions
2
Adjusting FR 13
• Remove the front cover and the right-hand
fender.
• Unscrew the nut (1) from the parallel strut.
Remove the clip (3) and the parallel strut (2).
• Turn the fork anti-clockwise to lower the rear
edge of the hood, or clockwise to raise the rear
edge of the hood.
• Once adjustment is complete, refit the parallel
strut and clip and tighten the nut.
• Recheck the alignment of the cutting unit after
adjustment.
• Refit the right-hand fender and hood.