46 – English
2
3
3
4
Reparation instructions
Removing the cutting unit
FRM 13 A
1
• Apply the parking brake.
• Adjust the cutting height to its lowest setting.
• Remove the front cover.
WARNING!
Wear protective glasses when
removing the cutting unit. The
spring which tensions up the belt
can go off and cause personal
injury.
Fit the two support wheels on each side of the
lower part of the deck.
Release the two support wheels under the front
cover.
Release the spring for the drive belt’s tensioning
wheel. Move the cutting height lever to the lower
position.
Place one foot on the front edge of the deck by the
wheel, and lift the front edge of the deck to simplify
releasing the height setting rod. Secure the rod in
the holder.
To Next Page
Loading...
