8 – English
1)
First change after 5 hours.
2)
Cleaning and replacing should be carried out more frequently in dusty conditions.
3)
The machine should
be lubricated twice a week if used daily.
4)
Carried out by authorised service workshop.
WARNING!
No service procedures must be conducted on the engine or cutting unit unless:
● = Described in this Workshop Manual.
❍ = Not described in this Workshop Manual.
▼ = Described in the Operating Instructions.
Maintenance interval in
hours
• The engine is switched off.
• The ignition key is removed.
• The ignition cables are removed
from the plugs.
• The parking brake is applied.
• The cutting unit is disengaged.
Maintenance schedule
The following is a list of the maintenance which should be conducted on the machine. Most of the points that
are not covered by this workshop manual are covered by the operator’s manual.
50
100
Page
25
Maintenance
Daily
maintenance
before
starting
Check the oil level in the engine 11 ●
Check the engine’s cooling air intake - ▼
Check the fuel pump’s air filter - ▼
Check the steering wires 25 ●
Check the brakes 28 ●
Check the battery 10 ●
Check the safety system 55 ●
Check the screws and nuts - ❍
Check if there is any fuel or oil leakage - ❍
Change the engine oil
1)
25 ●
Clean the air filter’s pre-filter (foam plastic)
2)
- ▼
Check the mower deck 44 ●
Check the tyre pressures (60 kPa) 12 ●
Lubricate the belt tensioner
3)
- ▼
Lubricate joints and axles
3)
- ▼
Adjust the brakes, FR 13 28 ●
Check the V-belts - ❍
Check the transmission’s cooling fins, - ❍
FRM 13 A
Check the transmission’s oil level, 43 ●
FRM 13 A
Adjust the brakes, Rider 13 and Rider 16 28 ●
Check and adjust the throttle wire 23 ●
Clean the cooling fins on the engine and transmission
2,4)
- ❍
Replace the air filter’s pre-filter and paper filter
2)
- ▼
Replace the fuel filter - ▼
Replace the spark plug - ❍
Delivery and dealer service
To Next Page
Loading...
