40 – English
7
6
10
~80
11
9
8
Reparation instructions
Draw the transmission wire along with the other
cabling. Place the wire at the bottom in the clamp,
under the articulated steering’s bearing.
Put the wire in position and screw tight the casing
with the rear clamp.
Adjust the wire as directed in “Inspection and
adjustment of speed regulator”. Connect the rear
linkage and fit the lock spring. Tighten the rear lock
nut for the linkage.
Check the setting of the neutral position contact.
Fix the hydrostatic transmission wire with a cable
ties.
Refit the frame plate using the four screws.
To Next Page
Loading...
