English – 41
7
6
10
~80
11
9
8
6019-026
6019-019
8009-203
6019-021
8009-214
Fasten the hydrostatic transmission cables with a
plastic binding.
Check the settings of the neutral position contact.
Screw on the frame plate, 4 screws.
Repair Instructions
Run the hydrostatic transmission cable along with
the other cables. Place the hydrostatic transmission
cable on the bottom in the cable bracket under the
articulated steering’s bearing.
Place the hydrostatic transmission cable in place
and screw the casing on with the rear bracket.
Adjust the hydrostatic transmission cable as shown,
see Checking and Adjusting the Accelerator.
Connect the rear link joint and attach the spring lock.
Tighten the rear link joint’s lock nut.
To Next Page
Loading...
