JOYTECH SL500DC - Advanced Menu Setting

27
L1
L2
L3
L4 L5
Cancel Auto-close function
L1
L2
L3
L4 L5
L1
L2
L3
L4 L5
L1
L2
L3
L4 L5
L1
L2
L3
L4 L5
L1
L2
L3
L4 L5
Indicator light status：
Off
On
Flicker
Status Instruction
Auto-close after 10 sec.
Auto-close after 20 sec.
Auto-close after 30 sec.
Auto-close after 40 sec.
Auto-close after 50 sec.
Table 2 Auto-Close Time
5.6 Advanced Menu Setting
1. Press “PROG” button for 3 Sec. under the control board standby mode, indicator light L0 will
flicker once, and then enter into basic menu setting. Press “PROG” button again for 3 sec. indicator
light L0 will flicker twice, and then enter into the advanced menu setting.
2. Different functions can be selected through “+” “-” buttons.
3. Press “SET” button to enter into the corresponding selection to set the parameters.
Working Mode Setting
L1
L2
L3
L4
L5
Acceleration Setting
L1
L2
L3
L4
L5
Start-up Delay Setting
L1
L2
L3
L4
L5
Standby Mode
Press and hold “PROG” button for 3 sec,
Advanced Menu Setting
Basic Menu Setting
Press “PROG” button again for 3 sec，
indicator light L0 will flicker once
indicator light L0 will flicker twice
Figure 29