12
Accessing System Mode
To access system mode, depress and hold the MODE LIST
key while turning on the transmitter. The System Mode
menu will appear. Select the desired function by moving the
cursor with the up or down key, then press the MODE LIST
key to enter the selected function.
Pressing the MODE LIST key while in the selected function
will return to the System Mode list, or pressing the UP and
DOWN keys simultaneously will return the display to the
Normal Mode.
Note: The servos will not operate in System Mode.
Select the normal display or the Function Mode to
operate the servos.
System Mode List
When entering System Mode, the System Mode list
automatically comes up. This list provides a complete list-
ing of all the available programming features in this mode.
When this list is displayed, pressing the UP or DOWN keys
will move the cursor to the desired programmng feature.
Access the desired feature by pressng the MODE LIST key.
Once in a function, return to the normal display by either
pressing the MODELIST key and then the CLR key, or press
the UP and DOWN keys simultaneously—both methods will
bring you back to the normal display.
Beginner/Expert Mode
The R-1 allows the racer to select between an expert mode
(all the advanced programming features are accessible) or
beginner mode (advanced features such as programmable
mix, trim rate, etc. ) do not come up in the menu list, making
programming less confusing for beginners. The Beginner/
Expert Mode is selected in Tx Mode (page 25). The
programming features which are deleted in the beginner
mode are marked with a ✔ on the previous page.
Accessing Function Mode
To access the Function Mode, first turn on the transmitter.
The normal display will appear. Now press the MODE LIST
key; DIRECT MODE will appear on the screen.
Pressing the Mode List key will display the function list or
pressing any of the other keys will directly access the func-
tion listed in orange on that key (see Direct Mode Access
section below).
Function Mode List
To display a complete listing of all the available
programming features in Function Mode when the Normal
display is shown, press the MODE LIST key two times. The
Function List screen will appear:
Press the UP and DOWN keys to move the cursor to the
desired programming feature. Access the desired feature by
pressing the MODE LIST key
Once in a functon, return to the Normal display by either
pressing the MODE LIST key and then the CLR key, or press
the UP and DOWN keys simultaneously—both methods will
bring you back to the Normal display.
Direct Mode Access
Direct Mode Access allows the direct access of the most
commonly used programming features, which include
steering expo, throttle curve, trim position, travel adjust,
model select, normal display and a custom key that’s factory
programmed to access the timer.
DIRECT MODE
[SYSTEM M.]
•INFO-DISP •Fail Safe
£REV.SW •TRANSFER
•FUNC. SEL •PROG.Mix1
•Trim RATE •PROG.MIX2
•MDL Name •TX MODE
•MDL Reset
•MODULAT.
[FUNC. LIST]
£D/R & EXP •IDLE UP
•Sub Trim •QUICK TH.
•TRVL ADJ •TIMER
•Model SEL
•THRO CURV •POS.
•SPEED ADJ
•A.B.S
To Next Page
Loading...
