16
Trim Rate
The trim rate function allows the trim authority (the amount
of trim available) to be adjusted. This is especially useful to
adjust the proper brake range available with the throttle trim
and throttle brake. Aux. 3 travel rate is also adjustable in this
function.
[Trim RATE]
ST.TRIM
70%
TH.TRIM AUX=3ch
∞ 70% 70%
TH.BRKE
ST.D/R
In System Mode, access the Trim Rate function by moving
the cursor to Trim RATEand pressing the MODE LIST key.
Press the SEL key to
select the desired trim
Press the UP key to go to
Function Select
Press the DOWN key to
go to Model Name
Press the CLR key to
reset the selected trim to
factory settings
Press the + or – keys to
adjust the trim rate value
Note: The Aux 3 channel can be assigned to any of the
digital trims (see page 15). The Aux 3 channel
rate is adjustable from 0–100% and gives
proportional function when a value of 0–100% is
selected. Above 100%, five step modes are avail-
able (1,2,3,4,5). When the step mode is accessed
(by pressing the + key), each time the digital
trimer is pressed, the Aux 3 servo steps to the
next position and is non-proportional.
To Next Page
Loading...
