14
Reverse Switch
Reverse switch is used to select the correct direction of the
servo’s travel.
[REV.SW]
¢
ch ST. TH. AUX.
REV
NORM
Press the SEL key to
select the desired
channel
Press the UP key to go to
Transmitter Mode
Press the DOWN key to
go to Function Select
Press the + or – keys to
reverse the selected
channel
NOTE:
The functions on the following pages are
accessed via the System Mode. To enter
System Mode, press and hold the MODE LIST
key while turning on the transmitter.
In System Mode, access the Reverse Switch function by
moving the cursor to REV.SW and pressing the MODE
LIST key.
To Next Page
Loading...
