JR Racing R-1 - Quick Start; Fail Safe; Sub Trim

2
Quick Start
Congratulations on your purchase of the most advanced
racing radio system available. We know you’re anxious to
get going with your new R-1, so we’ve provided this Quick
Start section that allows you to quickly set-up your new
radio with just the basic settings to get you to the track
quickly. When you’ve got time, we suggest that you read
each section in this manual to better understand the
advanced features of the R-1.
[REV.SW]
¢
ch ST. TH. AUX.
REV
NORM
[FUNC. LIST]
£D/R & EXP •IDLE UP
•Sub Trim •QUICK TH.
•TRVL ADJ •TIMER
•Model SEL
•THRO CURV •POS.
•SPEED ADJ
•A.B.S
[SYSTEM M.]
•INFO-DISP •Fail Safe
£REV.SW •TRANSFER
•FUNC. SEL •PROG.Mix1
•Trim RATE •PROG.MIX2
•MDL Name •TX MODE
•MDL Reset
•MODULAT.
Step 1. Install 8 AA batteries (not included) in the transmit-
ter. The battery door is located on the bottom of the
transmitter. The negative (flat) end of the battery goes
toward the spring.
Step 3. SERVO REVERSE: Now press the MODE LIST key
again. The screen should now look like this:
Press the SEL button to select the channel you wish to reverse,
then press the + or – key to change that servo’s direction.
Press and hold the MODELIST key
while turning on the transmitter.
Press the key a second time to
access the reverse switch screen
Press the + or – key to reverse
the servo direction of the
selected channel
Press the SEL key to select the
desired channel
Press the SEL key to select the
desired channel
Use the + or – key to adjust the
travel
Press the UP or DOWN key
until the cursor aligns with the
TRVL ADJ, then press the
MODELIST key
Press the MODE LIST key twice
after the transmitter is turned on
Indicates selected channel
Indicates REV or NORM is
selected
Step 2. Press and hold the MODE
LIST key while turning on the transmit-
ter. Your screen should look like this:
Step 4. TRAVEL ADJUST: Turn off the transmitter, then
turn it back on. Now press the MODE LIST key twice. Your
screen should look like this: