21
Example: Full brakes and straight steering. Press the CLR
key while holding the desired position with the throttle and
steering. A beep will indicate the position is stored and the
stored value will be displayed on the bottom center of the
screen.
Note: When using ZPCM, you can choose the amount
of time delay between the point of interference to
the time fail-safe is activated. This delay can be
set at 1/4, 1/2 or 1 second by pressing the + or -
key. Press the CLR key to store the desired fail-
safe positions.
To check that fail-safe is working correctly, turn off the
transmitter, thus eliminating the signal. The servos/speed
controller should go to the desired fail-safe position.
To Next Page
Loading...
