6. Setting
JCY-1800/1850 VDR/S-VDR Installation Guide
100
DOC No. 7ZPJD0387C
6.3. Analog Signal Converting Board (CEF-60) setup
The parameter setup of the following input signal is set up by the strap on PCB.
Other setup items are set up with maintenance software.
Refer to the instruction manual of maintenance software for details
1) Setting parameter of each channel
Items Parameter Remark
Input channel use YES (enable) / NO (disable)
Set “YES” by connecting analog signal or
“NO” by connecting no signal.
Input signal Voltage Current
Chooses the kind of signal.
±1V
±5V 4-20mA
Range
±10V
Choose the range of input signal.
A range setup is changed according to the
kind of signal.
2) Setting strap on the PCB (CEF-60)
CH0 CH1 CH2 CH3 CH4 CH5 CH6 CH7
To Next Page
Loading...
