4. Cabling
JCY-1800/1850 VDR/S-VDR Installation Guide
81
DOC No. 7ZPJD0387C
4.5. Assembling an Ethernet Connector (RJ-45 type)
Assemble an Ethernet connector according to the following procedure.
4.5.1. Assemble outside sheath of an Ethernet cable
Cut off outside sheath except for inner LAN Cable at the cable
let-in hole.
Only shielding wire needs to leave length to a chassis.
Wire an inner LAN cable with sheath into Radar.
4.5.2. How to assemble an Ethernet connector
1
Let the Ethernet cable pass through the cable boot.
2
Measure the length of the cable sheath that is to be
peeled.
NOTE: The rough standard is the length of your thumb
(about 5 to 6 cm).
3
Make a cut in the sheath by a wire stripper.
NOTE: Do not rotate the stripper over 360 degrees.
To Next Page
Loading...
