4. Cabling
JCY-1800/1850 VDR/S-VDR Installation Guide
82
DOC No. 7ZPJD0387C
4
Check by bending the cable that the foil inside is not
damaged. If the foil inside is damaged, cut the cable
there and go back to the procedure 2 again.
5
[Failure example]
The foil is torn and the core wires inside can be seen.
6
Cut the sheath by a cutter ver-tically from the cut line
made by the stripper in the procedure 3.
NOTE: Do not damage the foil inside.
7
Twist the cable to split off the sheath. Peel the sheath
along the cut lines made by the stripper and the cutter.
8
Check that the foil is not damaged after the sheath is
peeled. The foil is OK if it is not torn by the pull of
the arrow direction shown in the left figure.
Failure example
To Next Page
Loading...
