8. Troubleshooting
JCY-1800/1850 VDR/S-VDR Installation Guide
108
DOC No. 7ZPJD0387C
8.1.2. Symptom Table for The Data Processor Unit (NDL-46)
Symptom Causes Actions to be taken
The Recording Control Unit is off.
The power is not supplied to the Protective
Capsule Unit.
Check the switchboard.
Turn on the Power Supply Unit.
The recording of data onto the Protective Capsule
Unit has been stopped manually.
Press the REC START SWITCH on the Main
Control Board and restart the recording of
data.
Faulty wiring between the Recording Control
Unit and the Protective Capsule Unit
Check the Connection Box.
Check the LAN communication by a PING
command.
MCB: PING 192.168.110.3
Capsule: PING 192.168.110.2
In case a no response
MCB (CDJ-2304) :
Fault in a circuit board or setting data
Capsule :
Fault in a circuit board or setting data
REC LED fails to light.
Fault in the Recording Control Unit
Fault in the Protective Capsule Unit
Reboot the Recording Control Unit and see if
it works normally. If it does not work, contact
us.
Exchange a broken Unit (MCB or Capsule).
The CARD STOP SWITCH is left on. Press the CF CARD EJECT BUTTON and
remove it from the Main Control Board. Then
put it back again.
No CF CARD is loaded. Insert a CF CARD into the CARD slot of the
Main Control Board.
CARD LED fails to light
up.
Fault in the Recording Control Unit Reboot the Recording Control Unit and see if
it works normally. If it does not work, contact
us.
MEDIA LED blinks. Fault in the CF CARD Press the CF CARD EJECT BUTTON and
remove it from the Main Control Board. Then
put it back again.
In not activating, format the CF card into
FAT32 with PC.
No CF CARD is loaded. Insert a CF CARD into the CARD slot of the
Main Control Board.
Fault in the Recording Control Unit Reboot the Recording Control Unit and see if
it works normally. If it does not work, contact
us.
To Next Page
Loading...
