JRC JCY-1800 - Page 164

12. Configuration of Connection Interface
JCY-1800/1850 VDR/S-VDR Installation Guide
154
DOC No. 7ZPJD0387C
12.4.2.3. RADAR Signal Contact Interface
Equipment Name Manufacturer Model Serial No. Specification Remarks
X Band RADAR JRC JMA-9823-7XA
R/G/B/Hs/Vs: BNC connection
1024 x 728 pixels
Video: 0.7V peak at 75-ohm
Vs: 60 Hz / TTL / Negative
Hs: 48.36 kHz / TTL / Negative
Primary X-band
RADAR
12.4.2.4. Dry Contact Signal Connection Interface (For NCT-72(64CH)/63(16CH) DSC)
Port
No.
Equipment
Name
Manufacturer Model Serial #
Data
description
IEC61162-1
sentence
Source
Device
1 No.1 S/G Not yet decided Not yet decided No.1 S/G No voltage ALA
2 Alarm Panel No.1 S/G Overload Normal close ALA
3 No.1 S/G Lost phase
Normal close
ALA
4
No.1 S/G Low level of
oil pressure
Normal close
ALA
5
No.1 S/G Control power
failure
Normal close
ALA
6 No.2 S/G Not yet decided Not yet decided No.2 S/G No voltage Normal close ALA
7 Alarm Panel No.2 S/G Overload Normal close ALA
8 No.2 S/G Lost phase Normal close ALA
9
No.2 S/G Low level of
oil pressure
Normal close
ALA
10
No.2 S/G Control power
failure
Normal close
ALA
11 Auto Pilot Not yet decided Not yet decided
Auto pilot power source
failure
Normal close
ALA
12 P.A. main unit Not yet decided Not yet decided
P.A Main unit (E/E/R)
[emergency alarm]
Normal close
ALA
13 Not connected ----- ----- ----- ----- ----- -----
14 Not connected ----- ----- ----- ----- ----- -----
15 Not connected ----- ----- ----- ----- ----- -----
16 Not connected ----- ----- ----- ----- ----- -----
●
●
●
60 Not connected ----- ----- ----- ----- ----- -----
61 Not connected ----- ----- ----- ----- ----- -----
62 Not connected ----- ----- ----- ----- ----- -----
63 Not connected ----- ----- ----- ----- ----- -----
64 Not connected ----- ----- ----- ----- ----- -----