8. System Status Display
JCY-1800/1850 VDR/S-VDR Maintenance Software Instruction Manual
109
DOC No. 7ZPNA4014
8.3. Start System status display
8.3.1. When the diagnostic function is started
Since the diagnostic result is displayed, it is not necessary to operate it.
The [Diagnosis] button is a green display.
8.3.2. When the diagnostic function is stopped
When the diagnostic function has stopped, it is necessary to start a diagnostic function.
Click the [Diagnosis] button.
The [Diagnosis] button becomes a green display and a diagnostic result is displayed.
8.3.3. Stop the diagnostic function
Click the [Diagnosis] button during the diagnostic function operating.
The diagnostic function is stopped.
8.4. Diagnosis lamp of orange in normal operation
Even if the VDR/S-VDR is operating normally, some diagnosis lamps do not become a green.
1) Capsule
The “Capsule” section of the “Record Control” window
● “Write” lamp of “Config” partition
It becomes a green lamp display only immediately after transmitting configuration data.
If the RCU is rebooted, it will return to the orange display under diagnosis.
2) Microphone test
The “Audio” section of the “Record Control” window
● “Running test” lamps of “Microphone test”
A diagnostic lamp serves as an orange display under diagnosis until 12 hours pass and it carries out a
microphone test, after starting.
It is not necessary to check becoming a green lamp display at installation work.
To Next Page
Loading...
