5. SYSTEM Screen
JCY-1800/1850 VDR/S-VDR Maintenance Software Instruction Manual
82
DOC No. 7ZPNA4014
5.1. Common button on the SYSTEM screen
How to operate the function of the common button on the SYSTEM screen
1) [Receive] button
The Maintenance software receives the system configuration data of RCU
Click the [Receive] button, progress of data reception is displayed on the progress bar arranged at the lower of the
screen. The display of system screen will be updated by the received system configuration data.
2) [Diagnosis] button
Diagnosis function is controlled by the [Diagnosis] button.
Click the [Diagnosis] button, diagnosis function is started and the [Diagnosis] button becomes green.
3) [Set] button
It is used when setting up all system configuration information data.
Click the [Set] button, all configuration data is transmitted to the RCU.
* Set up the system configuration data of each section from the each detail setup window. It is unnecessary to use the
[Set] button on the System screen when the detail window is opened by revising setup data.
Use the [Set] button when all system configuration data should be set up or only the check box is revised.
4) [Reboot] button
It is used when rebooting the RCU.
Click the [Reboot] button, the RCU is operated by renewed system configuration data, after rebooting.
Wait until the communication link of Maintenance software and RCU is restarted.
5) [All Default] button
It is used when the system configuration data on the Maintenance software is initialized.
Initialized system configuration data is set up as the standard connection of the VDR/S-VDR.
To Next Page
Loading...
