9. Functions of Menu
JCY-1800/1850 VDR/S-VDR Maintenance Software Instruction Manual
113
DOC No. 7ZPNA4014
9.2.3. FGB maintenance mode
The MCB controls the FGB to record a image file during a VDR/S-VDR operating.
The FGB can not take maintenance while the MCB is communicating to the FGB with Ethernet link.
FGB maintenance mode means that the MCB disconnects the Ethernet link with the FGB.
* FGB-related functions make FGB maintenance mode start automatically.
It is not necessary to use this function.
1) Start
Click the [START] button.
2) Stop
Click the [Stop] button.
* Caution: Radar image can not be recorded during the FGB maintenance mode.
Be sure to stop this mode.
9.2.4. Initial Error Release
The Initial error (Error code: 01__) is released.
1) Click the [MCB] button.
9.2.5. Real Time Clock Setup
The date and time to the real time clock IC of the MCB or RMB can be confirmed and set up.
9.2.5.1. Display the date and time
1) Click the target unit button. ([MCB] button, [RMB] button)
The date and time of unit selected is displayed.
9.2.5.2. Set up the date and time
1) Click the target unit button. ([MCB] button, [RMB] button)
The date and time of unit selected is displayed.
2) Enter the date and time.
3) Click the [Set] button.
4) Click the [Reboot] button of the target unit. (Refer to the 9.2.1 clause)
5) When the unit is rebooted, the entered date and time is registered.
Confirm the date and time after rebooting.
To Next Page
Loading...
