11. Frame Grabber Board (CKA-137) setup - FGB utility -
JCY-1800/1850 VDR/S-VDR Maintenance Software Instruction Manual
122
DOC No. 7ZPNA4014
11.2.2. Select the channel for tuning
a) Click the icon.
If tuning the channel 2, click the
icon. And if “Ch2.txt NG” message appears, set the channel 2
capture setting using [Ch 2 capture setting] menu, refer to next section.
The following message appears. This message appears at first connected to the board.
b) Click the [OK] button.
c) "Changed to channel 1" message appears on left below status bar.
11.2.3. Check the board measured Radar image format
Check the board measured Radar image format as bellow.
a) Click [Information (I)] -> [ADC status] menu.
The following message appears.
b) Click the [No] button.
"ADCtxt_Analysis Function" window appears.
To Next Page
Loading...
