4. Installation, Setup and Check
JCY-1800/1850 VDR/S-VDR Maintenance Software Instruction Manual
18
DOC No. 7ZPNA4014
4.3.4. Detail setup window of sensor (standard)
4.3.4.1. Identification TAB screen
Set an identification data of connected equipment
1) Equipment
Enter the name of the connecting equipment. (GPS, Echo sounder, etc.)
* When except “Other” is selected, a default equipment name is entered automatically.
2) Model
Enter the model name of the connecting equipment.
3) Manufacturer
Enter the name of the manufacturer of the connecting equipment.
4) Serial No.
Enter the serial number of the connecting equipment.
* The old equipment by which the serial number is not displayed also exists. In that case, enter "unknown" into
the Serial No. column.
To Next Page
Loading...
