4. Installation, Setup and Check
JCY-1800/1850 VDR/S-VDR Maintenance Software Instruction Manual
24
DOC No. 7ZPNA4014
4.3.5. Detail setup window of GPS (sensor section)
Setup screen of GPS is a special screen for connecting two GPS.
Sub GPS setting is required when connecting two GPS to one port via a switcher.
4.3.5.1. Identification TAB screen
Set an identification data of connected GPS.
4.3.5.1.1. GPS information
1) Equipment
Enter the name of the connecting equipment. (GPS, DGPS, etc.)
2) Model
Enter the model name of the connecting equipment.
3) Manufacturer
Enter the name of the manufacturer of the connecting equipment.
4) Serial No.
Enter the serial number of the connecting equipment.
* The old equipment by which the serial number is not displayed also exists. In that case, enter "unknown" into
the Serial No. column.
4.3.5.1.2. Antenna position
Enter the four values for antenna position.
Distance from a Bow/Stern/Port/Starboard to an antenna
To Next Page
Loading...
