4. Installation, Setup and Check
JCY-1800/1850 VDR/S-VDR Maintenance Software Instruction Manual
54
DOC No. 7ZPNA4014
4.6.3.1.2. Setup file of FGB
The setup file of FGB can be downloaded and uploaded.
The setup file of FGB is saved in the “FGB_Util¥CKA137-JCY1800” folder under an install folder of maintenance
software.
A target Radar model or image specification is made into the file name.
Select a correct setup file with reference to the following.
● Radar model
Cap2-JMA9900-1800.txt
Cap2 "2" shows the object for FGB: CKA -137.
Reference:
When there is no numeric character (Cap-), the object for CKA-129 is shown.
JMA9900 Radar model
1800 The object for JCY-1800/1850 is shown.
Reference: 1700 shows the object for JCY-1700/S.
● VESA
Cap2-1024x768-60Hz-1800.txt
Cap2 "2" shows the object for FGB: CKA -137.
Reference:
When there is no numeric character (Cap-), the object for CKA-129 is shown.
1024x768 Image Resolution
60Hz Refresh rate
1800 The object for JCY-1800/1850 is shown.
Reference: 1700 shows the object for JCY-1700/S.
4.6.3.1.3. Two Radar images recording mode
Select a recording mode in case of connecting two Radars
1) Recording a image switched
The switching record mode is selected in standard system.
Select the “Single Record by Switch” from the pull-down menu.
2) Recording both images
The both record mode can be selected in the option system.
The option system means a large storage capacity of a capsule and a CF card.
Both Radar images can be recorded in the large storage capacity.
Select the “Dual Record” from the pull-down menu.
4.6.3.1.4. In case of using Radar Interface Unit
The Radar Interface Unit should be installed, when the display resolution of connected Radar unit is a UXGA size.
1) Setting a Radar interface unit mode
• When the Radar Interface Unit is installed, select the “NWP-46” from the pull-down menu.
• Enter a serial number of NWP-46.
*Caution: The Radar interface unit has a cooling fan. Fan alarm is neglected by the “None” setting.
To Next Page
Loading...
