4. Installation, Setup and Check
JCY-1800/1850 VDR/S-VDR Maintenance Software Instruction Manual
65
DOC No. 7ZPNA4014
4.8.3.1. Identification TAB screen
Set an identification data of connected VHF transceiver.
1) Model
Enter the model name of the connecting equipment.
2) Manufacturer
Enter the name of the manufacturer of the connecting equipment.
3) Serial No.
Enter the serial number of the connecting equipment.
* The old equipment by which the serial number is not displayed also exists. In that case, enter "unknown" into
the Serial No. column.
4.8.3.2. Real time monitor
Monitor the Audio of VHF transceivers which are recorded in the VDR/S-VDR at real time to check the operation is
working correctly.
Caution: Audio data is mixed by three input signal from each VHF transceiver.
1) Starting monitor
START: Click the [Play] button.
STOP: Click the [Stop] button.
2) Volume
Adjust sound volume by a slide bar.
Caution: When sound does not come out from a loudspeaker, check that the speaker output of PC is OFF or sound
volume is a minimum.
4) Diagnosis
Audio quality is judged by a manual.
Click the [Audio Quality check] button.
Judge an audio quality.
Click the radio button of judgment result
Enter a comment at NG.
* A click of the [Help] button displays advice of
an Audio quality judging.
To Next Page
Loading...
