Chapter 5 About Float-free Capsule
94
5.3.2 EXTENDED SELF-TEST
The test which is included GNSS test in the NORMAL SELF-TEST
1. Release front cover by removing the cotter pin.
2. To perform the EXTENDED SELF-TEST, do the following steps within a period of 3 seconds.
1) Move the switch to Test position.
2) Release middle position.
3) Move the switch to test position and release when the white test indicator lights up.
The white test indicator LED will light up and the green GNSS indicator LED will start flashing
in sequences of 3 fast flashes. This indicates that the EPIRB is searching for a validated
position.
When a valid position is found the green GNSS indicator LED will remain lit for approximately 1
second and a NORMAL SELF-TEST will continue.
The Strobe light will flash once at the end of the test if the EXTENDED SELF-TEST is
successful.
To Next Page
Loading...
