JRC JLR-7600 - Page 104

9-2
3) Interface
3-1) MID
(1) Serial Transmission
Channel Specification Notes
DATA IN/OUT1 RS-422 Input or Output NMAE, IEC
DATA IN/OUT2 RS-422 Input or Output NMEA, IEC
DATA IN/OUT3 RS-422 Input or Output NMEA, IEC
DATA IN/OUT4 RS-422 Input or Output NMEA, IEC Daisy chain
RS-485 RS-485 Input / Output NMEA, IEC
(1-1) NMEA
• Specification: NMEA
• Version: Ver1.5, 2.1, 2.3, 4.0
• Bit rate: 4800, 9600,19200,38400bps
• Data bit: 8bit
• Parity: None
• Start bit: 1bit
• Stop bit: 1bit
• Output sentence:
ALR,ACK,APB,BWC,BWR,CUR,DBK,DBS,DBT,DPT,DTM,GGA,GLL,GNS,HDG,HDM,
HDT,MDA,MHU,MMB,MTA,MTW,MWV,RMB,RMC,ROT,RPM,RSA,THS,VBW,VDR,
VHW,VLW,VTG,VWR,VWTXDR,XTE,ZDA,ZTG
• Output interval: 1s, 2s, 3s, 4s, 5s, 6s, 7s, 8s,9s, OFF
Note) Some combinations of output sentence, bit rate, and output intervals may not be possible.
(1-2) IEC
• Specification: IEC61162-1 ed.4
(2) Contact signal
3-2) Doppler Log
(1) Serial Transmission (Only output for DATA IN/OUT2 )
Channel Specification Notes
RS-485 RS-485 Output NMEA, IEC
(1-1) NMEA
• Specification: NMEA
• Version: Ver1.5, 2.1, 2.3, 4.0
• Bit rate: 4800, 9600,19200,38400bps
• Data bit: 8bit
• Parity: None
• Start bit: 1bit
• Stop bit: 1bit
• Output sentence: VBW,VLW
• Output interval: 1s, 2s, 3s, 4s, 5s, 6s, 7s, 8s,9s, OFF
(1-2) IEC
• Specification: IEC61162-1 ed.4
(2) Contact signal
Channel I/O Notes
CONTACT OUTPUT 200p/NM, 400p/NM
CONTACT INPUT ACK, Input of external dimmer
Channel I/O Notes
CONTACT INPUT Input of external dimmer