4-2
4.1 Basic Operation
4.1.1 Turning on the power
When the main power is turned on, the power to the display unit is automatically turned on.
In the state in which the power is turned off by the display unit key operation, pressing the
key turns on the power.
When the main power is OFF
Turning on the main power
When the main power is ON
Turning on the power
Pressing the power key
When the power is ON for first time.
The following screen is displayed. Select a Model with and press .
Model
When "LOG" is selected by mistake
Refer to Caution in "4.2.4 setting a model".
When "GPS" is selected by the first time power up and model setup for the prevention from
receiver breakage, the check of a receiver and display power supply voltage is performed.
Use a receiver and the display power supply voltage in the following combination.
Receiver Display power supply voltage
JLR-4341/4340 DC12~24V
excepct JLR-4341 / 4340 DC12V
If the power cannot be turned on, check the main power of the power distribution board
and the cable connection to the display unit.
JRC
ENT
ON
Supplement
To Next Page
Loading...
